Weatherproofing the Auber

restorick2378

New member
Anyone tried this?  The insides of this thing are pretty simple and should transfer easily to another case with proper planning.  Just wondering if anyone knows of a weatherproof case that might fit the bill.

If not, I have another idea up my sleeve that I'm dying to try out...  Stay tuned!  :-X  ;D

Rick
 
I thought of trying a clear plexiglass box 1/4 inch thick epoxied together with a hinged top and maybe a slot in the back for the cords, wouldn't be to expensive and maybe a couple hours labor.
 
The only thing you have to be careful about, if using a box, is heat.  The Auber has a heat sink, and the chips get pretty hot.  I would make sure you have some way to have airflow through the box when it's on.  I see the potential for some fried boards, if not cooled properly.
 
DivotMaker said:
The only thing you have to be careful about, if using a box, is heat.  The Auber has a heat sink, and the chips get pretty hot.  I would make sure you have some way to have airflow through the box when it's on.  I see the potential for some fried boards, if not cooled properly.

Yep. Those cooling fins on the bottom definitely want air movement.
 
DarbyDog said:
DivotMaker said:
The only thing you have to be careful about, if using a box, is heat.  The Auber has a heat sink, and the chips get pretty hot.  I would make sure you have some way to have airflow through the box when it's on.  I see the potential for some fried boards, if not cooled properly.

Yep. Those cooling fins on the bottom definitely want air movement.
Maybe pick up a fan for the box and run it off the smoke generator plug?
 
A fan in the box would be essential, I would think.  The problem there is you would need venting in the box for airflow, which kind of defeats the weather-proofing aspect. :(
 
It can be done, but this is another reason why I like a PID with the K-type thermocouples.....I can keep the PID in the house and run the K-type wire (and extension cord) outside...it's possible to go up to 100 feet or so with the K.


 
DiggingDogFarm said:
It can be done, but this is another reason why I like a PID with the K-type thermocouples.....I can keep the PID in the house and run the K-type wire (and extension cord) outside...it's possible to go up to 100 feet or so with the K.

That's cool!  Didn't know you could run that far!  Too bad Auber only has the single-probe unit with K! :(
 
DivotMaker said:
A fan in the box would be essential, I would think.  The problem there is you would need venting in the box for airflow, which kind of defeats the weather-proofing aspect. :(
Yes, unless you make slots in the bottom for air intake and outlet in rear for output. Might not pick up water but still exposed to extremely moist air.
 
Back
Top