Chip Screen Insert Question

[Smokin Jon]

Can anyone tell me the diameter of the holes and the thickness of the chip screen insert for a 3D smoker?

Thank you!

 

[smokeasaurus]

You might want to ask Steve on this one

 

[LarryD]

I just measured with a tape measure, so allow for a small margin of error.  I put the hole diameter at 1/8" and the thickness at 1/16".

 

[Smokin Jon]

Thank you very much!  I appreciate you taking the time to measure.

 

[Smokin Jon]

Steve answered my email.  The thickness is 20 Gauge (.0375 inch or .9525 mm)

 

[LarryD]

Steve answered my email.  The thickness is 20 Gauge (.0375 inch or .9525 mm)

Thank you for the follow-up...  I guess it's somewhat thinner than I measured.  I've always wanted to pickup a calipers; I guess I should go ahead and do that.  A tape measure just isn't that accurate at and under 1/16". (At least not in my hands...)