Author Topic: I everyone, I am new here, and need info, Yes look it up, OK.  (Read 410 times)

Smokey Old Man

  • Newbie
  • *
  • Posts: 1
    • View Profile
I everyone, I am new here, and need info, Yes look it up, OK.
« on: September 05, 2019, 07:49:26 PM »
I am getting a 2D smoker and would like to get the length between the legs, I want to mount it on an old tool box. There is no info on how far apart the legs are. My toolbox is 18" deep and I want it to obviously fit. I like the stand they sell, but I can't afford it and a toolbox is so much more practical and paid for. I Look forward to this site, I am not new to smoking, and am excited to use my new smoker, I could never tell my wife that I was excited to use a smoker, but here it is OK.

old sarge

  • Hero Member
  • *****
  • Posts: 2873
    • View Profile
Re: I everyone, I am new here, and need info, Yes look it up, OK.
« Reply #1 on: September 05, 2019, 08:19:53 PM »
First, welcome to the forum from SE Arizona. As for the spacing of the legs, side to side, front to back, you will need to wait for an owner of a 2D to chime in. In the mean time, why not visit the introduction section and share a little background and maybe a name.   Again, welcome.
David from Arizona
US Army 70 - 95
SI 3D & Big Red Controller
CS 066 (retired to my son's home)
Lodge Sportsman Grill
Weber Kettle
Ducane Meridian 42 inch Grill
LEM MaxVac 1088A
LEM Big Bite #8 Grinder
Chef's Choice 665 and Rival Slicers
Old Hickory Knives
InstantPot Duo80 Plus

chrisjadams

  • Newbie
  • *
  • Posts: 16
    • View Profile
Re: I everyone, I am new here, and need info, Yes look it up, OK.
« Reply #2 on: October 30, 2019, 10:06:32 PM »
Dimensions of my 2D legs are (from outside to outside):
15" front to back
17"side to side
Chris
Chandler, Arizona
Engineer, Scuba Instructor, International Scout lover, and Smoker
SI 2D

"Take the time it takes.  It takes less time."