Smokin-It User Forum!
Smokin-It Smokers => Model 2 & 2D - The Middle Kid => Topic started by: ReliableRick on July 01, 2020, 09:46:51 AM
-
I saw Ben from Ohio posted some great instructions for the Auber. Has anyone done something similar for the #2D controller? It has a lot of capabilities and can be a little overwhelming to start. New users would really benefit from a how to manual vs the supplied technical document.
-
These controllers have such garbage programming that there is little that can be done to really simplify the instructions. I did try to help someone out once by writing up something specific to them. Take a look and see if you think it might be helpful.
https://www.smokinitforums.com/index.php?topic=7604.msg67981#msg67981
-
Larry, this is the PDF I was looking for but couldn’t find it. Thanks for posting. I have it saved for future use now!
-
These controllers have such garbage programming that there is little that can be done to really simplify the instructions. I did try to help someone out once by writing up something specific to them. Take a look and see if you think it might be helpful.
https://www.smokinitforums.com/index.php?topic=7604.msg67981#msg67981
Thanks Larry. I'm in IT so I've been spoiled a little by more mature UI's. One of the tricks I would like to figure out is programming a presaved cook that I can set to 0 temp. I don't like that the element starts heating the minute I turn it on.
-
Have to admit it took me awhile to figure out the programming steps.. Mainly just used the pre-set recipes for my first year of cooks. Also found that really cold weather will sometimes impact the programming steps.. Have been using my 3-D for several years now and it is no longer an issue