AUBER WSD 1200 GPH purchased 12/2015 /#2
Using a back yard stone paver, probably 2.5 lbs...placed on middle rack - no water bowl - permanent probe about 1/2 inch below top rack (~4.25"below top) and checking against both Mav733 probes...
Bypassed #2
P = 72
I= 109
D= 277
Before bypass occurred (#2 all other things same)
P= 103
I= 115
D= 278
After bypassed tuning, I noticed that when setting up a program C1 = 322*F -1.5 hours, it climbed to 327*/328* and maintained there for at least 25 minutes, before I manually lowered the C1 time to make it drop towards C2 = 235*F. Is this normal to miss the target temp this much and stay there for that long?
*Also noticed that the MAV 733 probes read approx 14 and 20 degrees higher than AUBER , consistently, when temps are rising...and take around 1/2 hour to align with the Auber readout when falling/leveling from 322*F to target of 235*F.
Also noticed that when setting up a program C1 = 322*F -1.5 hours, it climbed to 327*/328* and maintained there for at least 25 minutes, before I manually lowered the C1 time to make it drop towards 235*F.
Are these PID numbers in the ballpark/OK? Wanting very much to tune this in tightly before my first "bypassed Auber" cook.