Smokin-It User Forum!
Auber PID Controllers => Auber PID Tips and Tricks => Topic started by: Smokin Jon on November 19, 2020, 10:12:44 PM
-
I've been manually stepping up temps on my 3D digital smoker. It will run 10 degrees F. over my setpoint then settle back to the setpoint. I let is sit for a particular time then ramp it up again. This has prolonged the smoke times and resulted in some great results. I would now like to simply program the smoker to operate independently in the same manner.
My Question:
Does the timer in Multi-step mode start when the temperature first reaches the setpoint or after it overruns the setpoint then settles back to the setpoint?
Hope that makes sense.
Thanks,
Smokin Jon
-
It should start when the set point is first reached.
-
Thank you sir!
Smokin Jon