Smokin-It User Forum!
General Discussions => Anything Goes!! => Topic started by: Smokin Jon on October 05, 2020, 06:37:54 AM
-
Can anyone tell me the diameter of the holes and the thickness of the chip screen insert for a 3D smoker?
Thank you!
-
You might want to ask Steve on this one
-
I just measured with a tape measure, so allow for a small margin of error. I put the hole diameter at 1/8" and the thickness at 1/16".
-
Thank you very much! I appreciate you taking the time to measure.
-
Steve answered my email. The thickness is 20 Gauge (.0375 inch or .9525 mm)
-
Steve answered my email. The thickness is 20 Gauge (.0375 inch or .9525 mm)
Thank you for the follow-up... I guess it's somewhat thinner than I measured. I've always wanted to pickup a calipers; I guess I should go ahead and do that. A tape measure just isn't that accurate at and under 1/16". (At least not in my hands...)