How to Reset Auto-Tune

[TDiggy]

Hey Smoking-IT Family,

I am auto tuning my PID and realized once I started that I didn't program the steps.  I turned off the Auber and turned it back on, programmed the steps, but the auto-tune keeps flashing.  Is this OK?  Will it auto tune with the correct steps or do I have to start the auto tune over?  If so, how do I do it?

• Tweet
• 

[SuperDave]

"-AT-" will flash for an hour to an hour and a half.  It will stop flashing when the auto tune is done.  Tell us what your PID results are and we can judge if it is in the ballpark.

[DivotMaker]

T, when you turn on the AT in settings, it will continue until complete, even if you change the program.  Made the same mistake on my first AT, too! 

[TDiggy]

OK.  The auto tune completed.  My results are:
P 68
I 626
D 156

Are we in the ballpark or do I need to let it cool and run autotune again?

[DivotMaker]

Looks pretty good, to me.  Smoke something, and see how close it holds.

[TDiggy]

Thanks DM...  You are da bomb dot com....  I will try to smoke something tomorrow.  Is there anything else I need to do?  If it doesn't come out as planned, should I try to auto tune again?

[DivotMaker]

I think those settings should keep it pretty close.  If it doesn't, let me know, and we'll take it from there!