Smokin-It User Forum!

General Discussions => Anything Goes!! => Topic started by: EFGM on February 04, 2018, 11:50:14 AM

Title: Use of Cell Phone Vehicle Attachment for Remote Temp Reading Device
Post by: EFGM on February 04, 2018, 11:50:14 AM

I use this on the Fireboard and it works great. It as well as other brands such as the Nano Mount could also be used.

1) Base Mount which sticks where you want it to be located. It has a ball which allows for 360* rotation
2) Ball side of Base Mount
3) Magnetic Disk that goes between Ball and Plate mounted on device.
4) Opposite side of Magnetic Disk
5) Magnetic Disk attached to Base Mount
6) Magnetic Disk rotated
7) Flat Plate that mounts on back of device.
8) FireBoard mounted
9) FireBoard rotated (obviously I had to support because Base Mount was not permanently mounted)
10) FB hooked up with probes (Base Mount is applied to window)

Title: Re: Use of Cell Phone Vehicle Attachment for Temp Control Device
Post by: old sarge on February 04, 2018, 11:56:44 AM

Nice!

Title: Re: Use of Cell Phone Vehicle Attachment for Remote Temp Reading Device
Post by: DivotMaker on February 04, 2018, 01:45:17 PM

Well that works great!!

Title: Re: Use of Cell Phone Vehicle Attachment for Remote Temp Reading Device
Post by: EFGM on June 02, 2018, 08:05:51 PM

Well with a little time the stickum on this one gave way. Switched it to tha NATO mount and all is good in the world again. NATO mount has been on both my vehicle dash boards for about 2.5 years. I should stuck with what worked for me.