Author Topic: First Smoke + Question  (Read 2592 times)

Doesitswim

  • Newbie
  • *
  • Posts: 4
First Smoke + Question
« on: December 06, 2015, 04:27:43 PM »
Doing my first smoke as I'm writing this. Spare ribs rubbed with olive oil and then Armadillo Willy's dry rub. Rack cut in two with tip on top shelf.

3 oz. of hickory chunks + 1 1/2 oz. of cherry chips. Started at 165 degrees for 30 minutes and then ramped up to 225 degrees for a planned additional 4 to 4 1/2 hours.

Temperature is by dial. I have a remote probe on order but haven't received it yet. Order this on Black Friday for $37.50 + free shipping: http://www.ebay.com/itm/321897224014?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Anyone have this one? Notice most people use Mavericks.

LOL..........doing my first smoke and already thinking #2 is too small already :)
Was planning on doing a Prime Rib roast for Christmas dinner for ten.

My question: When smoking something large like a roast, how much space should one leave between the meat and the wall of the smoker?

Any comments and suggestions will be greatly appreciated!

« Last Edit: December 08, 2015, 06:18:30 PM by Doesitswim »
Rich from Bay Area, California
Smokin-It #2, Weber Genesis 1000, Weber 22" kettle, Deep Fryer and Fishing Rods :)

SuperDave

  • Hero Member
  • *****
  • Posts: 2782
  • Officially Retired
Re: First Smoke + Question
« Reply #1 on: December 06, 2015, 04:37:52 PM »
Rich, I recommend a couple of inches for proper air and heat flow.
Model 4, Harrisville, Utah

gregbooras

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2414
  • #3D Smoker
Re: First Smoke + Question
« Reply #2 on: December 06, 2015, 05:00:59 PM »
+1

Greg

smokeasaurus

  • Hero Member
  • *****
  • Posts: 373
Re: First Smoke + Question
« Reply #3 on: December 06, 2015, 05:38:20 PM »
I agree that there should be some space. If cramped though, the roast will shrink during the cook.......should still be OK
Got Smoke?
Smokin It #2 and stand
Weber Performer
Weber Redhead
Gabby Grills Santa Maria and Rotisserie
PK Grill
Blackstone 36 inch Flat Top

SuperDave

  • Hero Member
  • *****
  • Posts: 2782
  • Officially Retired
Re: First Smoke + Question
« Reply #4 on: December 06, 2015, 05:55:51 PM »
Problems arise when the box temp probe is blocked by the meat. 
Model 4, Harrisville, Utah

smokeasaurus

  • Hero Member
  • *****
  • Posts: 373
Re: First Smoke + Question
« Reply #5 on: December 06, 2015, 06:05:54 PM »
Problems arise when the box temp probe is blocked by the meat.

Good call....important when positioning your protein..........
Got Smoke?
Smokin It #2 and stand
Weber Performer
Weber Redhead
Gabby Grills Santa Maria and Rotisserie
PK Grill
Blackstone 36 inch Flat Top

Doesitswim

  • Newbie
  • *
  • Posts: 4
Re: First Smoke + Question
« Reply #6 on: December 06, 2015, 11:15:46 PM »
Thanks everyone for the inputs.

My ribs looked really good after a total of 5 1/2 hours, but failed the toothpick test. I wrapped the ribs with foil and let them rest for 30 minutes after removing from the smoker, but they were still a little bit undercooked. Not falling off the bone at all as I was expecting. Couldn't wait any longer, so I finished them off in the oven.

Probably should of smoked at 235 degrees for 5 to 5 1/2 hours instead of spending 1/2 hour at 165 degrees.

Taste was very good. Smoke was a tad stronger than I like. Think I will go with maybe 2 oz. hickory and 1 to 1 1/2 oz. cherry next time. I was really surprised with the wood burn pattern. All the hickory chunks (Smokin-It) were ashes and the cherry chips (Cowboy's from Lowes) were mostly charred.

Guess I better put in some more smokes under my belt before Christmas dinner  ::)

« Last Edit: December 09, 2015, 12:53:05 PM by Doesitswim »
Rich from Bay Area, California
Smokin-It #2, Weber Genesis 1000, Weber 22" kettle, Deep Fryer and Fishing Rods :)

SuperDave

  • Hero Member
  • *****
  • Posts: 2782
  • Officially Retired
Re: First Smoke + Question
« Reply #7 on: December 07, 2015, 09:20:37 AM »
Yeah, I think you were too heavy on your total wood weight. 
Model 4, Harrisville, Utah