Author Topic: Auber ?  (Read 2646 times)

allmann

  • Sr. Member
  • ****
  • Posts: 117
Auber ?
« on: September 14, 2015, 09:36:21 AM »
I have a question though about the Auber, I have it set 140 for 30 min; then 235 til meat hits 195; then supposed to go to 140 incase I was out running errands.  I forgot to put the meat probe in last night. I woke up this morning and did so(0730). It was holding at 235 all night even when I checked on it at 0130. I added the meat probe, it read 178, but the the temp started to drop on the box temp. I just chalked it up to me opening the door. 30 min later it kept going down. I shut it off and restarted it and its still not kicking on. What did I do wrong?
Kevin
Lacey NJ

SuperDave

  • Hero Member
  • *****
  • Posts: 2782
  • Officially Retired
Re: Auber ?
« Reply #1 on: September 14, 2015, 10:10:43 AM »
When you shut it off and restarted it, you were back in program 1, 140. 
Model 4, Harrisville, Utah

elkins20

  • Hero Member
  • *****
  • Posts: 1141
  • Smokin it best electric smoker bar none!
Re: Auber ?
« Reply #2 on: September 14, 2015, 11:24:02 AM »
It should go thru the steps and get to the correct one. It not just re-program it and skip step one. Just do the 235 step and then the hold at 140.
Bill SI#1, SI#3, 2 Auber Pids, Cold Smoke Plate for the #3, Large Weber kettle, Smoky Joe Weber, and 2006 Harley softail deuce for stress relief,  from Kansas City, Missouri

allmann

  • Sr. Member
  • ****
  • Posts: 117
Re: Auber ?
« Reply #3 on: September 15, 2015, 09:21:15 PM »
Yea it started at step one I had to up the temp for step one to 235
Kevin
Lacey NJ

FunkedOut

  • Sr. Member
  • ****
  • Posts: 112
  • SI3 Pro Modified
Re: Auber ?
« Reply #4 on: September 16, 2015, 12:16:21 AM »
well, I just replied to this question in your other thread.
now I see it's already been answered here.  ::)
Joe, in FL
Smoking It #3, Auber PID WSD-1500GPH, 23cfm of boost

DivotMaker

  • Hero Member
  • *****
  • Posts: 10988
  • Model 1, 2D conversion, and 3D!
Re: Auber ?
« Reply #5 on: September 16, 2015, 10:10:41 PM »
This is why we should avoid asking the same question on multiple boards...gets confusing.  Pick a board, ask your question, and wait for replies! ;)
Tony from NW Arkansas
"Official Smokin-It Test Pilot"
Smokin-It Model 1, 2D conversion, and 3D
Auber PID, NexGrill 896 6-burner, CharBroil Big Easy, Anova Precision Cooker w/WiFi
Wife, Son and One REALLY Big Dog!