Smokin-It User Forum!

Problems and Troubleshooting => Having a problem? Look Here First, or Post Your Question! => Topic started by: SuperDave on December 06, 2016, 08:34:37 PM

Title: Analog question
Post by: SuperDave on December 06, 2016, 08:34:37 PM

If the red light stays on 50 degrees past the set temp is that a calibration issue or a bad rheostat?

Title: Re: Analog question
Post by: SuperDave on December 07, 2016, 01:28:29 PM

Played with it a little more this morning and power kicks back on pretty close to set point, -10, but just doesn't shut off when it is supposed to.  Any thoughts would be much appreciated.

Title: Re: Analog question
Post by: DivotMaker on December 11, 2016, 03:17:17 PM

Sounds like the rheostat may be going out, Dave.  I'd contact Steve...should still be under warranty.