Smokin-It User Forum!
Auber PID Controllers => Auber PID Tips and Tricks => Topic started by: curegeorg on August 17, 2016, 03:33:57 PM
-
I am trying to set up auber for a brisket program. Its a GPH1500 stand along Auber. Probe is mounted in the box and one drop in.
I turn it on and it is displaying the two temps. I push set. It displays C01 which I changed to 225. I push set again and it goes back to displaying the two temps. It does not let me get into the steps, etc. What am I doing wrong? Per the instructions I should go from C01 225 to E01, but it just goes back to displaying probe temps.
-
I called Auber. Previous owner had it programmed single setting not stepped. Problem solved. There is a code to change from the two settings under the LCK programming mode.
666 was the reset code. 3 was the code for changing between a stepped cook and just single regulated temp cook. 166 is the code for tuning it. Just an FYI. I guess most people don't get a used controller, but in case you forget. Default setting is the stepped cooking so you may have never even known it has a constant regulated setting...