Smokin-It User Forum!
Auber PID Controllers => Auber PID Tips and Tricks => Topic started by: allmann on September 14, 2015, 09:36:21 AM
-
I have a question though about the Auber, I have it set 140 for 30 min; then 235 til meat hits 195; then supposed to go to 140 incase I was out running errands. I forgot to put the meat probe in last night. I woke up this morning and did so(0730). It was holding at 235 all night even when I checked on it at 0130. I added the meat probe, it read 178, but the the temp started to drop on the box temp. I just chalked it up to me opening the door. 30 min later it kept going down. I shut it off and restarted it and its still not kicking on. What did I do wrong?
-
When you shut it off and restarted it, you were back in program 1, 140.
-
It should go thru the steps and get to the correct one. It not just re-program it and skip step one. Just do the 235 step and then the hold at 140.
-
Yea it started at step one I had to up the temp for step one to 235
-
well, I just replied to this question in your other thread.
now I see it's already been answered here. ::)
-
This is why we should avoid asking the same question on multiple boards...gets confusing. Pick a board, ask your question, and wait for replies! ;)