Smokin-It User Forum!

Auber PID Controllers => Auber PID Tips and Tricks => Topic started by: Gary on August 17, 2015, 09:50:30 PM

Title: Location of Permanent Probe on Model 1
Post by: Gary on August 17, 2015, 09:50:30 PM

I am installing permanent mount tomorrow on my model 1.. Just want to double check. Will I have it right if I place it in the middle and down just below the top rack?

Title: Re: Location of Permanent Probe on Model 1
Post by: SuperDave on August 17, 2015, 10:45:05 PM

Gary, while there is a video with that location, the majority go with center and 1" from the top. 

Title: Re: Location of Permanent Probe on Model 1
Post by: elkins20 on August 18, 2015, 01:33:19 AM

Hi Gary, I also have a #1 and placed my permanent wall probe on the left side of the center support and 1 1/4" from the top. When you get inside and all the insulation is out, you can see the top. I measured from right underneath the insulation on the top shelf. Sorry but did not take any photos as it looks like all the others.

Title: Re: Location of Permanent Probe on Model 1
Post by: DivotMaker on August 18, 2015, 07:27:27 PM

Go 1 - 1 1/4" below the top.  Any lower, and you will find yourself jamming meat into it. ???