Smokin-It User Forum!
Smokin-It Smokers => Model 3 & 3D - The Big Brother => Topic started by: Becausethewind on March 26, 2023, 02:30:17 PM
-
Hi. I’m having a difficult time with understanding how to install the Bella cold smoker into the side of the 3D. There is a hole drilled that is plugged in both sides. I was able to remove outside plug but inside won’t come off and I can’t get it out. Is there any method to removing it
-
Not speaking from any actual knowledge here, but it seems like if you got the outside plug/cap out then you should be able to run a long screwdriver or a small pipe (rigid copper pipe?) through and knock it out with a couple light taps.
-
we are a go!
took some force prying which i was trying to avoid since normally you don't wanna forcefully remove anything... but i finagled it out and got the bella hooked in .. cold smoking some soy sauce i fermented for 3 years in it now with some cherry wood branches from my garden and red oak. :)
-
Good to see you have it up and working!