Smokin-It User Forum!
General Discussions => Mods and Adjustments => Topic started by: Jim_MI on December 31, 2023, 06:36:52 PM
-
Proud owner of a shiny new #3DW. I plan on doing a good bit of cold smoking, with my new Bella CSG. I was looking at some YouTubes about the Bellas and noticed a LOT of smoke "patina" staining on the exterior of the SI smoker they were using, all situated around and above where the Bella smoke tube and lid vent are situated. So I am considering applying a sacrificial sheet of aluminum roof flashing to the exterior sidewall of the #3DW, just to protect the finish.
New to SI and Bella so I would really appreciate any input from Bella owners on how big of a cosmetic problem this is. And if it is a problem, are there any tried-n-true solutions yet?
TIA, Jim
-
I cannot offer any solution. What I can say is that any surface the smoke touches will get some form of patina. It is easily washed off. Youre idea about a sacrificial piece of flashing should solve all or part of your concern. I might add that a lot of new users of these smokers that rely on a compression fit rather than a door seal have voice concerns over smoke seaping out of the door. Perfectly normal. I had the same concerns. All is well!