Smokin-It User Forum!
Smokin-It Smokers => Model 1 - The Little Guy!! => Topic started by: sizzler on December 29, 2017, 11:48:34 PM
-
Looking at a Model 1 for the RV, I would have to remove the ac cord bracket on the backet (looks to be screws) in order for it to fit in a compartment. Is there an issue of transporting on it's back if I remove the inside wood smoker box and possibly racks?
-
Howdy sizzler I recently purchased a number 1 and it shipped without the cord brackets installed. I also didn't install the wheels as my intentions were to bring it along in the rear storage area of our RV. To transport, my plan is to use a blanket for padding and remove all the racks and wood box. The only issue I can determine is the top analog temp control switch which is about an inch+ tall. The side handles are flush so it should transport on any side or back without a problem and my only concern is vibration which the blanket should be sufficient to reduce.
I think your plan to take the #1 RV'ing is good and that's what actually influenced my purchase of the #1 over the #2 initially.
-
TX Gent, thanks for the advice, I spoke to Steve and confirmed there is no issue transporting the smoker on it's back, placing order in a few minutes. I just hope the outside dimensions of a height include the legs for the wheels but understand that the wheels are not included in this measurement